Preparing The Room - Installing The Machine - Esmach SPI 160 A hybrid Notice D'utilisation Et De Maintenance

Instruction for use and maintenance
Spiral mixer with removable bowl SPI 160-300 A HYBRID
SECTION B – POINT 2

PREPARING THE ROOM - INSTALLING THE MACHINE

PREPARING THE ROOM
The room where the machine is installed and any existing equipment already installed in the
room must comply with the directives, regulations, standards and technical specifications etc. in
force in the user's country (E.U. or EFTA).
INSTALLING THE MACHINE
The purchaser/user or his representative must check the condition of the machine upon unpack-
ing, immediately notifying the manufacturer of any damage or defects encountered.
For installation of the machine, the specifications on the identification label illustrated in Section
A point 1 and the overall dimensions given in Section A point 2 should be taken into account. To
guarantee an optimal use of the machine it is necessary to follow the present installing proce-
dure:
1. clean accurately the floor zone on which will be placed the ma-
chine so that the feet with anti-slide rubber have a better adhe-
sion to the floor (figure n° 14)
2. Put the machine on the floor making sure there is an area of ap-
proximately 50 cm all around the machine for use and mainte-
nance
3. fix the safety spacer tube (figure n°15) of the machine in the rear
zone in order to let the head raise automatically and avoid acci-
dental crushing of the operators between the cover and the wall
under the machine
4. at this point switch on the machine (figure n° 16) following the
instructions as per Section B—Point 3
5. after having verified that all runs in the correct way, push con-
temporarily the common button and the button to lift the head
and unhook the trolley (figure n° 17)
22
Figure n° 14
Figure n° 15
Figure n° 16
Figure n° 17