Replacing Wheels; Replacing A Fuse - EMAK 91 Manuel D'utilisation

6.3.2 Replacing wheels

Stop the machine on flat ground and put
a block under a load-bearing part of the
frame on the side that the wheel is to be
changed.
The wheels are held by a snap ring
(1) which can be eased off with a
screwdriver.
NOTE If you have to replace one or
both rear wheels, make sure that any
differences in their external diameter
does not exceed 8-10 mm; on the
contrary, to prevent an uneven cut it will
be necessary to adjust the alignment of
the cutting deck.
IMPORTANT
the wheel, apply grease to the axle. Put
the snap ring (1) and supporting washer
(2) back in place.
6.3.3 Replacing and repairing
the tyres
The tyres are "Tubeless" and so all
punctures must be repaired by a tyre
repairer following the procedures required
for this kind of tyre.
EN 28
2 1
Before remounting
6.3.4 Replacing the bulbs (if present)
The bulbs (18W) have a bayonet fitting
and are installed in the bulb holder
which can be taken out by turning it anti-
clockwise with pliers.

6.3.5 Replacing a fuse

The machine is fitted with fuses (1)
with different capacities and functions.
Specifically:
– 10 A fuse = protects the main and
power circuits of the electronic circuit
board. When it blows, the machine
stops and the dashboard light switches
off.
– 25 A fuse = protects the battery charger
circuit. When it blows, the battery
gradually runs out and the machine will
have problems starting.
1
The fuse capacity is indicated on the fuse.
IMPORTANT
1
always be replaced by one of the same
type and ampere rating, and never with
one of another rating.
If problems persist, contact Your Dealer.
1
1
A blown fuse must