Directions Before Starting; Seat Adjustment; Tyre Pressure - EMAK 91 Manuel D'utilisation

5.3 DIRECTIONS BEFORE STARTING

WORK
Before starting to mow, it is necessary to
carry out several checks and operations
to ensure you can work efficiently and in
maximum safety.

5.3.1 Seat adjustment

To change the
seat position,
loosen the four
fixing bolts
1
(1) and slide
it along the
slots.
Once you
have found the
right position,
tighten the four
screws (1).

5.3.2 Tyre pressure

Having the right tyre pressure is the main
condition for ensuring that the cutting
1,5 bar (13 x 5,00-6)
1,0 bar
(15 x 5,00-6)
deck is horizontal
and mows evenly.
1,2 bar
Unscrew the valve
caps and connect a
compressed air line
with a gauge to the
valves and adjust
EN 16
1
1,2 bar
the pressure to the indicated values.
5.3.3 Filling with oil and fuel
NOTE The engine manual indicates
what type of oil and fuel you can use.
With the engine off, check the oil level.
According to the instructions in the engine
manual, this must be between the MIN
and MAX marks on the dipstick.
Refuel using
a funnel,
but do not
completely
fill the tank.
The tank's capacity is about 6 liters or 4.5
liters.
DANGER!
Refuelling should be
carried out in an open or well-
ventilated area with the engine off.
Always remember that petrol fumes
are inflammable. DO NOT USE A
NAKED FLAME TO LOOK INSIDE
THE TANK AND DO NOT SMOKE
WHEN REFUELLING.
IMPORTANT
plastic parts to avoid damaging them.
In the event of accidental spills or leaks,
MAX
MIN
o not drip petrol onto the