EMAK 91 Manuel D'utilisation page 84

– To engage forward drive, press it
towards «F» with your toe-cap. As
you increase the pressure on the
pedal, the speed of the machine
increases.
– Reverse is engaged by pressing the
pedal with the heel towards «R».
– The pedal automatically goes into
neutral «N» when released.
WARNING!
reverse when the machine has
stopped moving.
NOTE
If the drive pedal is used,
whether forwards or for reverse, the
engine stops as soon as the parking
brake (4.4) is engaged.
4.33 HYDROSTATIC
TRANSMISSION
DISENGAGEMENT LEvER
This lever has two positions as shown
on the label:
«A» = Transmission engaged: for all
uses, when moving and during
cutting;
«B» = Transmission disengaged: this
makes it much easier to move
the machine by hand, with the
engine turned off.
IMPORTANT
the transmission unit, this operation
must be carried out only when the
engine has stopped with the pedal
(4.32) on position «N».
EN 14
Only shift into
To avoid damage to