Grass Cutting - EMAK 91 Manuel D'utilisation

from causing tipping up and loss
of control of the vehicle,
particularly on slopes.
5.4.3 Braking
First reduce the machine's speed by
reducing the engine's r.p.m., and then
press the brake pedal (
slow down the machine until it stops.
Hydrostatic transmission
The machine already slows down
considerably by just releasing the drive
pedal.
5.4.4 Reverse
IMPORTANT
engaged only when the machine has
stopped moving.
Mechanical transmission
Press the pedal until the machine stops
and then go into reverse by shifting the
lever sideways and into position «R»
( 4.22). Gradually release the pedal
to engage the clutch and then begin
moving in reverse.
Hydrostatic transmission
When the machine has stopped
moving, start reversing by pressing the
drive pedal in direction «R» (

5.4.5 Grass cutting

Model 102
Adjust the position of the anti-chipping
wheels (1) whose function is to reduce
the risk of tearing up sections of lawn,
which can occur when the edge of
the cutting deck drags over irregular
ground.
4.21 or 4.31) to
Reverse must be
4.32).
The four different heights of the wheels
allows you to maintain a safe distance
«A» between the cutting deck edge
and the ground.
1
A = 10 mm
A = 30 mm
To change
the position,
unscrew and
remove the
pin (1) then
reposition the
wheel (2) in
the upper and
lower hole of
the wale corresponding to the wheel
diameter.
WARNING!
always be performed on both
wheels, positioning them at the
same height WITH THE ENGINE
OFF AND BLADES DISENGAGED.
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as
possible;
– only use the blade (
lawns, do not use the blades on stony
ground or when the grass is very high.
– start moving forwards on the grass
very slowly and with utmost caution, as
already described;
– regulate the cutting height and speed
( 4.8) considering the conditions of
the lawn (the height, density and
dampness of the grass).
A = 0 mm
A = 20 mm
A
2
This should
4.7), on grass
EN 19
1