Interventions On The Machine - EMAK 91 Manuel D'utilisation

6.2.2 Rear axle
This is a sealed single unit that does not
require maintenance. It is permanently
lubricated and its lubricant does not need
changing or topping up.
6.2.3 Battery
The battery must be carefully maintained
to ensure long life.
The machine battery must always be
charged:
– before using the machine for the first
time after purchase;
– before leaving the machine disused for
a long period;
– before starting up the machine after a
long period of disuse.
Carefully read and observe the battery
recharging instructions in the booklet
provided with the battery. Failure in
following the instructions or in charging
the battery could permanently damage the
battery cells.
1
1
A flat battery must be recharged as soon
as possible.
IMPORTANT
be done using a battery charger at
constant voltage. Other recharging
systems can irreversibly damage the
battery.
The machine comes with a connector (1)
for recharging; this is connected to the
corresponding connector for the special
"CB01" or "FIGHTER" maintenance
battery-charger supplied (if included) or
available on request (
IMPORTANT
only be used for connection to the
"CB01" or "FIGHTER" maintenance
battery-charger. For its use:
– follow the instructions in the relevant
user manual,
– follow the instructions in the battery
manual.
6.3 INTERvENTIONS
ON THE MACHINE
6.3.1 Cutting deck alignment
The cutting deck should be properly set to
obtain a good cut.
If the cut is uneven, check the tyre
pressure.
If this is not sufficient to achieve an even
cut, please contact your Dealer for the
adjustment of the alignment of the cutting
deck.
Recharging must
9.5).
This connector must
EN 27