EMAK 91 Manuel D'utilisation page 88

– if the engine is already warm, position
the lever between «SLOW» and
«FAST»;
– put in the ignition key and turn to «ON»
to make electrical contact, then turn to
«START» to start the engine;
– release the key once the engine has
started.
When the engine has started, move the
throttle to «SLOW».
IMPORTANT
closed as soon as the engine is running
smoothly. Using it when the engine is
already warm can foul the spark plugs
and cause the engine to run erratically.
NOTE If there are engine starting
problems, do not insist as you can risk
running the battery flat and flooding the
engine. Turn the key to «OFF», wait
for a few seconds and then repeat the
operation. If the malfunction persists,
refer to the engine manual and chapter
«8» in this manual.
IMPORTANT
mind that the safety devices prevent
the engine from starting if safety
requirements have not been
met ( 5.2).
In these cases, once the situation has
been corrected, the key must first be
turned back to «OFF» before the
engine can be restarted.
5.4.2 Starting and moving without
mowing
WARNING!
not been approved for use on public
roads. It has to be used (as indicated
by the highway code) in private
areas closed to traffic.
EN 18
The choke must be
Always bear in
This machine has
When moving the machine:
– disengage the blades;
– bring the cutting deck to the highest
position (position «7»);
– put the accelerator control between the
«SLOW» and «FAST» positions.
Mechanical transmission
Push the pedal down as far as possible
( 4.21) and move the gear change
lever into 1st gear (
Keep the pedal pressed down and
release the parking brake. Slowly
release the pedal to shift from «brake»
to «clutch», thus operating the rear
wheels ( 4.21).
WARNING!
be released gradually, as a
sudden engagement may cause
the vehicle to tip over and the
driver to lose control.
Gradually reach the desired speed
using the throttle and gear lever. To
change gear, press the clutch halfway
down ( 4.21).
Hydrostatic transmission
Disengage the parking brake and
release the brake pedal (
Press the drive pedal (
direction «F» and reach the required
speed by progressively increasing
pressure on the pedal and moving the
accelerator.
WARNING!
engaged as described (
to prevent sudden engagement
4.22).
The pedal has to
4.31).
4.32) in
Drive must be
4.32)