Troubleshooting - EMAK 91 Manuel D'utilisation

8. TROUBLESHOOTING

PROBLEM
1. When the key is
turned to «RUN»,
the
indicator light or
the control panel
remain switched off
2. With the key on
«START» the light
flashes and the
starter motor does
not run
3. With the
key is turned to
«START» the light
or the control panel
come on, but the
starter motor is not
activated
4. With the key
on «START», the
starter motor runs
but the engine does
not start
EN 30
LIKELY CAUSE
The safety device of the electronic
circuit board has cut in due to:
– badly connected battery
– battery terminals crossed
– completely flat battery
– fuse blown
– electronic circuit board wet
– conditions are not met to allow
starting
– insufficiently charged battery
– malfunction on the starter relay
– insufficiently charged battery
– faulty fuel supply
– faulty ignition
SOLUTION
Turn the key to «STOP» and look
for the cause of the problem:
– check connections (
– check connections (
– recharge the battery (
– replace the fuse (10 A) (
– dry using tepid air
– check that the conditions allowing
starting are met (
– recharge the battery (
– contact Your Dealer
– recharge the battery (
– check the level in the tank (
– open the fuel stopcock (if present)
( 5.4.1)
– check the fuel filter
– check that spark plug cap is
securely fitted
– check that the electrodes are clean
and have the correct gap
3.4)
3.4)
6.2.3)
6.3.5)
5.2.a)
6.2.3)
6.2.3)
5.3.3)