End Of Work - EMAK 91 Manuel D'utilisation

WARNING!
sloping ground, re duce your speed
to ensure safe conditions (
5.5).
Whatever the conditions, always reduce
the speed if you notice a drop in engine
speed – if you travel too fast compared to
the amount of grass being cut, you will not
be able to mow the grass well.
Disengage the blades and raise the
cutting deck as high as possible whenever
you need to get past an obstacle.
5.4.6 Emptying the grass-catcher
NOTE This operation can only be done
with the blades disengaged, otherwise
the engine stops.
Do not let the grass-catcher become
too full as this may block the collector
channel.
When the grass-catcher is full you will
hear a sound warning. At this point:
– disengage the blades
( 4.7) and the sound will stop;
– lower the engine speed;
– shift into neutral (N) (
Mechanical transmission or 4.32
Hydrostatic transmission) and stop
moving forward;
– engage the parking brake on slopes;
– pull out the lever (1- if fitted) or grasp
1a 1
EN 20
When cutting on
1.2 -
4.22
2
the rear handle (1a) and tip up the
grass-catcher to empty it;
– close the grass-catcher so that it hooks
onto the pawl (2).
5.4.7 Unblocking the collector channel
Cutting very tall or wet grass, particularly
at excessively high speed, can clog up the
collector channel. If this happens proceed
as follows:
– stop moving forward, disengage the
blades and stop the engine;
– remove the grass-catcher or the rear
discharge guard;
– remove the grass cuttings; you can
reach them from the exit of the collector
channel.
WARNING!
performed with the engine turned
off.
5.4.8 End of mowing
When you have finished mowing,
disengage the blades, lower the engine
speed and ride the machine with the
cutting deck raised as high as possible.

5.4.9 End of work

Stop the machine, move the throttle
to «SLOW»
and turn off
the engine by
turning the key to
«OFF».
When the engine
has stopped,
close the fuel
stopcock (1) (if
fitted).
This job must only be
1