Starting - EMAK BCH 250 Manuel D'utilisation Et D'entretien

Put the pin provided in the appropriate hole (L)
to block the blade and allow the bolt (A) to be
tightened to 2.5 kgm (25 Nm).
WARNING – Collar (see arrows C, Fig.7)
must locate in blade's mounting hole.
FITTING THE HANDLE (Fig. 2)
Fit the handle (A) onto the shaft arm and secure it
using screws (D). The handle position is calculated
depending on the requirements of the operator.
WARNING - Assemble the loop handle (A,
Fig.2-3) between label's arrow (B) and rear
handle (C).
FITTING THE HANDLEBAR (FIG.5B)
- Loosen the clamp screws (D).
- Insert the 2 halves of the handlebar in the
respective sockets (E).
- Retighten the screws (D)
MOUNTING THE CONTROL HANDLES (Fig. 5A)
- Loosen the screw (G, Fig.6). The nut (H) remains
in the control handle (L).
- Push the control handle (L) (throttle trigger M
must point toward the gearbox) onto the bike
handle (N) so that the holes (P) line up.
- Insert screw (G) and tighten down firmly.
ASSEMBLING THE BIKE HANDLE (Fig. 5C)
- Place the bike handle (A, Fig.4) in the lower hub
(B1).
- Place the upper hub (B2) in position and tighten
the 4 screws (D), without finally tighten yet.
- Line up the handlebar at a right angle to the
drive tube.
- Tighten down the screws (D) firmly.
WARNING:
components are connected properly and all
screws tightened.
PREPARING TO WORK
HARNESS (3, Fig. 1)
Correct adjustment of the harness permits the
brush cutter to be properly balanced and at an
appropriate height from the ground (Fig. 8).
Make sure that
- Put on the single harness.
- Hook the brush cutter to the harness using the
hook (A, Fig. 8).
- Position the hook (18, Fig. 1) to obtain the best
brush cutter balance.
- Position the buckle (C) to obtain the correct
brush cutter height (Fig. 9).

5. STARTING

FUELING
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution when
handling gasoline or fuel mix. Do not smoke
or bring any fire or flame near the fuel or the
unit.
· To reduce the risk of fire and burn injury,
handle fuel with care. It is highly flammable.
· Mix and store fuel in a container approved for
gasoline.
· Mix fuel outdoors where there are no sparks or
flames.
· Select bare ground, stop engine, and allow to
cool before refueling.
· Loosen fuel cap slowly to release pressure and
to keep fuel from escaping around the cap.
· Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
fuel cap to loosen or come off and spill
quantities of fuel.
· Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting
engine.
all
· Never attempt to burn off spilled fuel under
any circumstances.
· Do not smoke while handling fuel or while
operating the unit.
· Store fuel in a cool, dry, well ventilated place.
· Never place the machine in a combustible
area such as dry leaves, straw, paper, etc.
· Store the unit and fuel in an area where fuel
vapors cannot reach sparks or open flames
from water heaters, electric motors or
GB
25