Transporting - EMAK BCH 250 Manuel D'utilisation Et D'entretien

come into contact with the ground during
normal cutting. Constant contact of this type
can cause damage and wear to the trimmer
head.
Sweeping
• The fan effect of the rotating cord can be used
for quick and easy clearing up. Hold the cord
parallel to and above the area to be swept and
move the tool to and fro.
• When cutting and sweeping you should use
full throttle to obtain the best results.
WARNING: Never cut, when visibility is
poor or in very high or low temperatures or in
freezing weather.

8. TRANSPORTING

TRANSPORTION
Carry the brush cutter with the engine off and with
the protective blade cover on (Fig. 3).
ATTENTION: Fit the disk protection p.n.
4196086 as shown (Fig. 3) before transporting or
storing the brushcutter.
WARNING – When transporting the
machine in a vehicle, ensure that it is properly
secured using belts. The machine should be
transported in a horizontal position with the
tank empty, ensuring compliance with applicable
regulations for transport of such machines.
9. MAINTENANCE
EMISSIONS COMPLIANCE
This engine, including the emissions control
system, must be operated, used and maintained
in accordance with the instructions provided
in the user's manual in order to maintain
the emissions performance within the legal
requirements applicable to non-road mobile
machinery.
No deliberate tampering with or misuse of the
engine emissions control system has to take
place.
Incorrect operation, use or maintenance of the
engine or of the non-road mobile machinery
could result in possible malfunctions of the
emissions control system to a point where the
legal requirements applicable are not respected;
in such case a prompt action must be taken in
order to rectify the system's malfunctions and
restore the applicable requirements.
Examples, not exhaustive, of incorrect operation,
use or maintenance are:
- Forcing or breaking the devices for metering
the fuel;
- Use of fuel and/or engine oil not fulfilling the
characteristics shown in the chapter STARTER /
FUELING;
- Use of not original spare parts, for example
spark plug, etc. ;
- Missing or improper maintenance of the
exhaust system, including incorrect timing of
maintenance for muffler, spark plug, air filter,
etc.
WARNING – Tampering with this engine
makes the EU emissions certification no more
valid .
The level of CO2 of this engine can be found
in the Emak's website (www.emak.com) under
section "The Outdoor Power Equipment World".
GB
31