• With groups of hardwood stems, first clear
around the group. Start by cutting the stems
high up around the outside of the group to
GB
avoid jamming. Then cut the stems to the
required height. Now try to reach in with the
blade and cut from the centre of the group. If
it is still difficult to gain access, cut the stems
high up and let them fall. This will reduce the
risk of jamming.
8. TRANSPORTING
TRANSPORTION
Carry the brush cutter with the engine off and with
the protective blade cover on (Fig. 3).
ATTENTION: Fit the disk protection p.n.
4196086 as shown (Fig. 3) before transporting or
storing the brushcutter.
WARNING – When transporting the
machine in a vehicle, ensure that it is properly
secured using belts. The machine should be
transported in a horizontal position with the tank
empty, ensuring compliance with applicable
regulations for transport of such machines.
34