Transporting - EMAK Efko DS 3500 S Manuel D'utilisation Et D'entretien

blade may catch or jerk the clearing saw
forward. This may cause damage to the blade
or loss of control of the clearing saw which
GB
may result in serious injury.
WARNING: A saw blade can only be
used in connection with the proper guard
(see table pag.38) a twin handle and double
harness with release mechanism.
Brush cutting with a saw blade
• Thin stems and brush are mown down. Work
with a sawing movement, swinging sideways.
• Try to cut several stems in a single sawing
movement.
• With groups of hardwood stems, first clear
around the group. Start by cutting the stems
high up around the outside of the group to
avoid jamming. Then cut the stems to the
required height. Now try to reach in with the
blade and cut from the centre of the group. If
it is still difficult to gain access, cut the stems
high up and let them fall. This will reduce the
risk of jamming.

8. TRANSPORTING

TRANSPORTION
Carry the brush cutter with the engine off and with
the protective blade cover on (Fig. 3).
ATTENTION: Fit the disk protection p.n.
4196086 as shown (Fig. 3) before transporting or
storing the brushcutter.
WARNING – When transporting the
machine in a vehicle, ensure that it is properly
secured using belts. The machine should be
transported in a horizontal position with the tank
empty, ensuring compliance with applicable
regulations for transport of such machines.
34