Transporting; Storage; Environmental Protection - EMAK PPX 271 Manuel D'utilisation Et D'entretien

applies at idle speed. Contact can result in
burns to the skin. Remember the risk of fire!
GB
CAUTION! - If the muffler is damaged, it
must be replaced. If the muffler frequently
becomes blocked, this could be an indication that
the efficiency of the catalytic converter is limited.
WARNING – Do not use the pole pruner
if the muffler is damaged or missing, or has
been altered in any way. Operating the
machine with an improperly maintained
muffler will increase the risk of fire and
hearing loss.
EXTRA MAINTANANCE ADVISABLE
It is advisable to inspect the machine by a
specialized technician at an authorized service
network at the end of season, if used intensively,
and every two years if with normal use.
9. TRANSPORTATION
Carry the pole pruner with the engine off and
with the protective blade cover on (Fig. 8).
WARNING – When transpor ting the
machine in a vehicle, ensure that it is properly
secured using belts. The machine should be
transported in a horizontal position with the tank
empty, ensuring compliance with applicable
regulations for transport of such machines.
ATTENTION: All maintenance operations
not reported in this manual must be carried
out by an authorized Service Center. To ensure
steady and regular pole pruner operation,
remember that parts must only be replaced with
ORIGINAL SPARES.
Any unauthorized changes and/or use of
non-original replacement parts may result in
serious injury or death to the operator or third
parties.

10. STORAGE

If the machine is to be stored for long periods:
- Drain and clean the fuel and oil tank in a well-
ventilated area.
30
- Dispose of fuel and oil according to the rules
and respecting the environment.
- Clean the pole pruner completely and lubricate
the metallic parts.
- Remove, clean and spray it with protective oil
the chain and the bar.
- Store the blower in a dry place, preferably not
in direct contact with the ground, away from
heat sources and the tanks empty.
ATTENTION: Fit the protection as shown
(Fig. 8) before storing the pole pruner.

11. ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of
considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Scrupulously comply with local regulations and
provisions for the disposal of waste materials
after mowing.
- Scrupulously comply with local regulations and
provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be disposed
of as normal waste, it must be separated and
taken to specified waste disposal centres
where the material will be recycled.
Demolition and disposal
When the machine reaches the end of its service
life, do not dispose of it into the environment;
instead take it to a waste disposal centre.
Most materials used in the manufacture of the
machine are recyclable; all metals (steel,
aluminium, brass) can be delivered to a normal
recycling station. For information contact your
local waste recycling service. Waste disposal must
be carried out with respect for the environment,
avoiding soil, air and water pollution.
In all cases, applicable local legislation must
be complied with.
When the machine is scrapped also the CE mark
label must be destroyed together with this
manual.