Maintenance - EMAK PPX 271 Manuel D'utilisation Et D'entretien

8. MAINTENANCE

Please note that the following maintenance intervals apply for normal operating
conditions only. If your daily work requires longer than normal or harsh cutting
conditions are present the suggested intervals should be shortened accordingly.
Complete Machine
Controls (Ignition Switch, Choke Lever,
Throttle Trigger, Trigger Interlock)
Fuel Tank and Oil Tank
Fuel Filter
Chain Lubrication
Saw Chain
Guide Bar
Rim Sprocket
Chain Catcher
All Accessible Screws and Nuts (not
Adjusting Screws)
Air Filter
Cylinder Fins and Starter System Vents
Starter Rope
Carburetor
Spark Plug
Bevel Gear
MAINTENANCE CHART
Inspect (Leaks, Cracks, and Wear)
Check Operation
Inspect (Leaks, Cracks, and Wear)
Inspect and Clean
Replace Filter Element
Check Output
Inspect (Damage, Sharpness, and Wear)
Check Tension
Sharpen (Check Gauge Depth)
Inspect (Damage, and Wear)
Clean Bar groove and Oil Passages
Rotate, Lubricate Sprocket Nose and
Deburr
Replace
Inspect (Damage, and Wear)
Inspect (Damage, and Wear)
Replace
Inspect - Retighten
Clean
Replace
Clean
Inspect (Damage, and Wear)
Replace
Check Idle (Chain must not rotate at Idle)
Check Electrode Gap
Replace
Inspect (Damage, Wear and Grease Level)
X X
X X
X X
X
X
X X
X X
X X
X
X X
X
X
X
X
X X
X
X
X
X
X
X
X
X X
X
X
X
GB
Every 6
Months
Replace with
every new
chain
Every 6
Months
Every 6
Months
27