Display Of Previous Training With Average And Maximum Values - Kettler GOLF M Mode D'emploi Et Instructions D'entraînement

RECOVERY function
Recovery pulse measurement
Press "RECOVERY" at the end of training.
The pulse value is stored (P1).
The current pulse is still displayed.
The electronics assembly of the training device mea-
sures your pulse 60 seconds in reverse.
The pulse value after 60 seconds (P2) is stored.
The pulse difference (P1-P2) is displayed
From this value, a fitness mark (F 4.8 for this exam-
ple) is determined.
The display is completed after 20 second.
"RECOVERY" interrupts the recovery pulse function
or the fitness mark display.
If no pulse is measured in the beginning or at the
end of the reverse counting, the error message
"Err" is displayed.
.
Display of previous training with
average and maximum values
• Press "Persons": selection of persons
Display: "Person 1 flashes, total training time and
kilometres"
• Switch persons using "Plus" or "Minus"
• Confirm person with "DISP/SET"
• Press "Persons" once more:
Display:
Average values of pulse, % pulse, RPM,
km/h and brake level of the previous training are
displayed with the [Ø] symbol.
• Press "DISP/SET"
Display:
: Average values of pulse, % pulse, RPM,
km/h and brake level of the previous training are
displayed with the [MAX] symbol.
• Press "DISP/SET"
Display:
Readiness for training with or without pre-
settings.
Comment:
The last training values only refer to the previous
training unit. The values are stored by "RESET" or
by the activation of the stand-by mode with time dis-
play deleting previous values.
Pulse REC Start
(P1)
fitness mark
Display of aver-
age values [Ø]
Display of max.
values
[MAX]
FB601
(P1- P2)
actual pulse
Pulse after 60s
(P2)
19
GB