7.1
Replacing the fuse
›
DANGER
›
›
›
›
›
8
Repair - Maintenance - Return
In case of service requests contact your local Starlab sales representative or Starlab service technician.
IMPORTANT
Contact details can be found "Starlab Service Hotline" or the back page.
20 · Aspirator · Manual
Switch off the pump.
Disconnect the electrical power cord before opening the terminal box.
After disconnecting from power, wait 5 seconds to allow the capacitors to discharge.
Identify and eliminate the cause of failure before switching on the equipment again.
K eep the snap-fit squeezed and pull the fuse holder out.
The fuse holder contains two fuses of the same type. Replace the defective fuse with a fuse of the same type (see
"Technical data")
Insert the fuse holder into the housing of the pumping unit until it snaps into place.