Assembling Quick Coupling Bottle - Pump Unit; Quick Coupling Sets - StarLab Aspirator Mode D'emploi

5.3

Assembling quick coupling bottle - pump unit

Attention: The extension set "Quick coupling bottle - pump unit" is designated for two different extension versions. Therefore, the set
consists of parts which may not be necessary in each individual case. Redundant parts are not credited by Starlab.
Assembling to pump inlet
Remove tubing.
Disassemble hose nozzle.
Hold counter piece with open-ended wrench size 19 mm.
Assemble coupling (2) with seals (1, 3) and hose nozzle (4).
Hold counter piece with open-ended wrench size 19 mm.
Connect tubing.
Assembling to an additional bottle
Assemble coupling part (1) with seal (2) and
hose nozzle (3).
Connect tubing.
5.4

Quick coupling sets

Quick coupling set: Hand controller to bottle
Quick coupling made of PVDF, with adapter to connect a hand controller to a collection bottle. When disconnected, the
collection bottle closes vacuum tight.
Quick coupling set: Bottle to pump unit
Quick coupling made of PVDF, to connect a collection bottle to a Aspirator. When disconnected, the collection bottle
closes vacuum tight.
Attention: The quick-coupling accessory sets between the pumping unit and hand controller are not suitable for use
NOTICE
with sodium hypochlorite (chlorine bleach).
Aspirator · Manual · 17