Assembling Of Components; Replacing The Filter; Assembling A Second Hand Controller Connection Set - StarLab Aspirator Mode D'emploi

5

Assembling of components

5.1

Replacing the filter

Vent the collection bottle.
Ensure that there is no liquid in the tube to avoid risk of contamination.
Remove connecting tube from the filter. Remove the filter from the piece of tube at the hose nozzle.
Attach new filter.
Observe flow direction. Position filter with the printed side "FACING DOWN" towards the bottle.
Attach the connecting tube.
5.2 Assembling a second hand controller connection set (with / without coupling) or conversion to quick coupling hand
controller - bottle
Empty bottle.
Decontaminate equipment if necessary.
Remove filter with connection tubing from bottle head.
Remove screw cap from the collection bottle.
Unscrew closing screw.
Only Aspirator with polypropylene bottle: Remove counter nut inside the screw cap.
Aspirator with polypropylene bottle
Insert hose connection (1a) with seal ring (2) or coupling (1b) with seal ring (2) in the screw cap.
Secure lead through with counter nut (3). Assemble hose (4) under the screw cap to the lead through.
Aspirator with glass bottle (accessory)
Screw hose connection (1a) with seal ring (2) or coupling (1b) with seal ring (2) into the screw cap.
Assemble hose (3) under the screw cap to the lead through.
Screw cap onto bottle.
Assemble filter.
Assemble hand controller.
16 · Aspirator · Manual