Display Parameters - A.E.B. AEB215 Manuel D'utilisation

DISLAY PARAMETERS
MAIN MENU
When the Hand-Held Tester (updated to 2.10 version) is connected to a GALILEO ECU, the "MAIN
MENU" consists of two options:

• DISPLAY PARAMETERS;

• VEHICLE CONFIGURATION.
DISPLAY PARAMETERS (Fig. 1)
This page (Fig. 2) displays those parameters that are necessary to
verify for correct operation of the E.C.U..
The display parameters are:
ACT: real time indication of the position of the stepper motor expressed
in steps.
DEF: average operational position (default) of the actuator.
This position is memorized by the E.C.U. and expressed in steps.
RPM: real time indication of engine RPM.
TPS: real time indication of the THROTTLE POSITION SENSOR signal
voltage, expressed in volts (V).
The four marks beside the T.P.S. value graphically display the
position of the butterfly and provide the following indications:
ššš Idle T.P.S..
™ ™ ™ ™ ™ ššš
ššš ššš ššš
šš šš Out-of-idle T.P.S..
š š š š š ™ ™ ™ ™ ™ šš
šš šš
šš šš ™ ™ ™ ™ ™ š š š š š T.P.S. in learning area; The memorized default position
šš šš šš
can be updated by the E.C.U..
ššš ™ ™ ™ ™ ™ T.P.S. in full power area.
ššš ššš
ššš ššš
LBD: real time indication of the Oxygen Sensor signal voltage,
expressed in volts (V). The three marks beside the Oxygen Sensor
value graphically displayed the carburetion status:
šš šš lean mixture.
™ ™ ™ ™ ™ šš
šš šš
š š š š š ™ ™ ™ ™ ™ š š š š š stoichiometric mixture or cold sensor.
šš šš ™ ™ ™ ™ ™ rich mixture.
šš šš šš
Is215-2 Rev. 110105-2
GALILEO
(AEB170TC and AEB170TCEI versions)
GALILEO
MAIN MENU
DISPLAY
PARAMETERS
Fig. 1
ACT 95 DEF 100
RPM 1700 RPM
TPS 0.80 V ™ ™ ™ ™ ™ ššš
ššš ššš ššš
ššš
LBD 0.20 V ™ ™ ™ ™ ™ šš
šš šš šš šš
Fig. 2
61 - 188