Arneg Colonia 3 G2 Mode D'emploi page 42

Colonia 3 - Mini Colonia
English
Wipe the surfaces with a soft cloth.
ATTENTION!
Delicate surfaces, glass. Dents, scratches, corrosion, wounds, broken glass
- DO NOT aim the jet directly on the varnished or plasticised surfaces
- DO NOT apply the detergents directly onto the surfaces to be cleaned
- DO NOT use steam cleaning equipment
- Do not use excessive force
- DO NOT bring the jet too close to the dirt. This may cause injury to the operator and
contaminate parts that have already been cleaned, as well as the environment.
- prevent the detergents from coming into contact with the goods present nearby.
ATTENTION!
Floor products. Vapours. Corrosione. Difficulties in breathing.
- avoid contact, inhalation.
Internal cleaning with high pressure washers (Fig. 15) :
use LOW PRESSURE systems (max 30 bar) with a flow rate suitable to remove any
residue present
21.3. Clean the external parts (Daily/Weekly)
Clean all the external parts of the cabinet on a week basis (cap.21.2.).
21.4. Clean the internal parts (Monthly)
In addition to respecting the "General instructions" (cap.21.2.) proceed as follows:
Step
1 empty the cabinet completely from the goods it contains.
2 remove all the removable parts, such as display dishes, grids etc.
3 wash with lukewarm water (max 30°C).
4 disinfect using a detergent with an antibacterial component.
Carefully clean the bottom tank, the drip tray and the grid that protects the water
5
drain, eliminating all foreign bodies that have fallen through the suction grid lifting, if
6 dry thoroughly with a soft cloth.
i
For the formation of ice, contact a specialist refrigeration technician.
21.5. Clean the sliding doors
PROCEDURE:
Step
1 lift the price-tag holder profile (fig. A)
2 lift and remove the covers (fig. B)
3 proceed to clean (cap.21.3.)
4 remove the covers
5 reposition the cover profile
21.6. Clean specific materials
Material
Glass Use a soft cloth with a neutral
detergent or lukewarm water (max
30°C) and neutral soap.
immediately remove all traces of
water and detergent with a dry
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
42
Action
Action
procedure Avoid
DO NOT use hot water on cold glass
surfaces; the glass could crack and
injure the operator.
DO NOT use rough or abrasive
materials or metal scrapers that
could scratch the glass surfaces
DO NOT use dirty cloths
05060154 00 26/05/2014