Hach NA5600 sc Na+ Mode D'emploi page 8

1. From the main measurement screen, push the LEFT arrow to show the graphical display.
Note: Push the UP or DOWN key to show the graph for the previous or next channel in sequence.
2. Push home to change the graph settings.
3. Select an option.
Option
MEASUREMENT VALUE Sets the measurement value range on the graph for the selected
DATE & TIME RANGE
Section 4 Configuration
4.1 Set the language
1. Push menu, then select SETUP SYSTEM > LANGUAGE.
2. Select the language that shows on the display and in the log files.
4.2 Remove channels from the measurement screen (2- or 4-channel ana-
lyzers)
Remove the channels that are not measured (e.g., 4-~SAMPLE4) from the measurement screen.
Change the order that the channels show on the measurement screen as necessary.
1. Remove the channels that are not measured (e.g., 4-~SAMPLE4) from the measurement screen
as follows:
a. Push menu, then select SETUP SYSTEM > DISPLAY SETUP > ADJUST ORDER >
REMOVE MEASUREMENTS.
b. Select the channels that contain the symbol "~" (e.g., 4-~SAMPLE4), then push enter two
times.
Note: To add a channel to the measurement screen, select ADD MEASUREMENTS.
2. To change the order that the channels show on the measurement screen, select an option.
Option
SEE CURRENT ORDER Shows the order that channels show on the measurement screen.
REORDER LIST
SEE DEFAULT ORDER Shows the default order that channels show on the measurement
SET TO DEFAULT
4.3 Set the display brightness
1. Push menu, then select SETUP SYSTEM > DISPLAY SETUP > DISPLAY BACKLIGHT.
2. Enter a number from 1 to 9 (default: 5). Select a higher number to increase the brightness.
4.4 Set the maximum rinsing time
Set the maximum time interval the analyzer rinses the measurement cell at startup and immediately
after reactivation, grab sample measurement, calibration and prime reagents.
8 English
Description
channel. Select between AUTO SCALE and MANUALLY SCALE.
Enter the minimum and maximum ppb value in the MANUALLY
SCALE menu.
Selects the date and time range to show on the graph: last day, last
48 hours, last week or last month.
Description
Sets the order that channels show on the measurement screen.
screen.
Sets the order that channels show on the measurement screen to the
default order.