Hach NA5600 sc Na+ Mode D'emploi page 28

4. Follow the instructions on the display.
5. When prompted, add the water sample to the overflow vessel until the water level is between the
top mark (+) and the bottom mark (-). Push enter.
When the measurement is done, the results show on the display.
6.3 Show the measurement, calibration and event logs
Note: The analyzer stores a maximum of 18,000 data points. After 18,000 data points are stored, the oldest data
points are overwritten with new data.
1. Push menu and select VIEW DATA > LOG DATA.
2. Select an option.
Option
VIEW DATA LOG
VIEW EVENT LOG
VIEW CALIBRATION LOG
VIEW GRAB SAMPLE LOG
3. Select an option.
Option
START TIME
NUMBER OF HOURS
NUMBER OF READINGS Shows the selected number of data points.
6.4 Save data or settings to an SD card
Save the data logs to an SD card to use the data on a PC as necessary. Save the analyzer settings
to an SD card so the settings can be restored later or copied to another analyzer as necessary.
Items to collect:
• SD card (2 GB or more)
• PC with SD card slot
1. Put an SD card in the SD card slot (2 GB minimum). Refer to
2. Push menu, then select SD CARD SETUP.
3. Select an option.
Option
UPGRADE
SOFTWARE
28 English
Description
Shows the saved measurements.
Shows the events that have occurred.
Shows the saved calibrations.
Shows the saved grab sample measurements.
Description
Shows the data recorded after the selected date and time.
Shows the data recorded within the selected number of hours
before now.
Description
Note: The UPGRADE SOFTWARE option only shows when a software update file
is on the SD card.
Installs the software update file that is on the SD card. Refer to
the latest software version
Figure 11.
on page 29.
Install