Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
8.6
CLEANING THE WATER
COLLECTING TRAY
Clean the drip container with hot, soapy water.
NOTE: The water collecting tray can be washed in
the dishwasher.
Never use any sort of solvent.
8.7
CLEANING THE
GASKET
Use a small brush to clean any deposits or
coffee residues off the piston and the delivery
unit site or any other areas soiled with coffee.
Fig. 33
CAUTION
Fig. 34
8.8
CLEANING THE
MILK FOAMER
TALENTO PLUS
NOTE: Follow the instructions applied on the label on
the inside of the front door too.
IMPORTANT: Proceed with caution
Remove the lid of the pouring nozzle by pulling
it towards you.
Remove the cappuccino maker from the nozzle
by sliding it upwards.
Disconnect all of the connected pipes.
Remove the cappuccino maker and wash it
with care.
NOTE: For intervals of more than three hours
between one cappuccino and the next, it is
advisable to wash the cappuccino maker by
taking in water through the milk suction pipe
instead of milk.
To reassemble proceed inversely, attaching the
milk foamer tubes properly.
NOTE: To make the reassembling procedure easier,
an explanatory label has been attached to
the front door.
Fig. 35
53
Publicité
Table des Matières
