Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRE-BREWING (Pre-infusion Time):
It is possible to read the pre-infusion time in sec.
Pressing the ENTER
open the submenu. Press the RESET
to exit the setting.
TAMPING (Pressing):
It is possible to read if pressing is on or off (YES or NO).
Pressing the ENTER
open the submenu. Press the RESET
to exit the setting.
DILUTE:
It is possible to set the volume, in cc of hot water to
add to the beverage.
Pressing the ENTER
enter the submenu with the keys to increase/reduce
the volume of hot water.
Press ENTER
to confirm the setting.
MULTICYCLE (multiple cycles):
It is possible to read the number of cycles set.
Press the ENTER
Press RESET
to quit the setting function.
MILK TIME (Milk Time):
It is possible to set the time and therefore, the
amount of milk.
Pressing ENTER
sub menu; the
increase/reduce the amount of milk.
Press ENTER
to confirm settings.
NO AIR TIME (Air Time disabled):
It is possible to read the part of the total milk time in
which the air solenoid is closed in order to regulate
the amount of foam in the milk.
Pressing the ENTER
open the submenu.
Press the RESET
48
key, it is possible to
key
key, it is possible to
key
key, it is possible to
key to open the submenu.
it is possible to enter the
keys are used to
key, it is possible to
key to exit the setting.
AUTOWASHING (Automatic milk tube wash):
It is possible to read the wash time with cold water at
the end of milk dispensing.
Pressing the ENTER
open the submenu.
Press the RESET
To program the double dose, after entering the menu
for the required key:
COFFEE
Press the
: key: it will be possible to pro-
gram the same list of functions for the double dose.
PAUSE (MACCHIATO cycle only):
It is possible to set the pause (in seconds) between
the milk and coffee (min 0 - max 20).
Press the ENTER
the keys can then be used to increase/reduce the
pause.
Press ENTER
to confirm the setting.
TEMPERATURE (milk temperature)
TALENTO SPECIAL only:
It is possible to set the temperature of the milk.
Press the ENTER
the keys can then be used to increase/reduce the
temperature of the milk drink by a maximum of ±
10%.
Press ENTER
to confirm the setting.
DELAY (steam delay)
TALENTO SPECIAL only:
It is possible to read the steam delay time so as to fill
the .pipe with milk before foaming it with the steam.
Press the ENTER
Press RESET
to quit the setting function.
EN
key, it is possible to
key to exit the setting.
X
key to open the submenu,
key to open the submenu,
key to open the submenu.
Publicité
Table des Matières
