Coffee Holder And Coffee Delivery Unit Cleaning; Cleaning The Steam Nozzle; Cleaning The Drop Collecting Tray Grid - Nuova Simonelli TALENTO Notice D'instructions

Reposition a container with 1 litre of fresh water, and
press ENTER , the machine will carry out a
rinse cycle and the display will read:
RINSE
RESTORING AN INTERRUPTED WASH CYCLE
If the washing cycle is interrupted by cutting off power
to the machine, when it is switched on again, the
group will position itself in the standby phase and the
display will read:
AUTOWASHING
OPEN DOOR
Insert Cleanser
CLOSE DOOR
1. Open the front hatch of the machine.
2. Place a detergent tab (Puly Caff) inside the
pouring chamber.
3. Use a damp cloth to wipe clean the shower head
on the top piston.
4. Close the front door on the machine.
8.3 COFFEE HOLDER AND
COFFEE DELIVERY
UNIT CLEANING
RISK OF BURNS OR SCALDING
Set the machine to the "O" energy level.
Insert the key in the lock.
Turn the key to open the hatch anticlockwise.
Open the front hatch.
Remove any coffee residues that may have
deposited on the sides of the conveyor using
the fine brush provided.
52
CAUTION
Fig. 29
Use a damp cloth and/or a little mild detergent
to clean the coffee bean bells.
8.4 CLEANING THE STEAM
NOZZLE
Clean the steam nozzle each time it is used to warm
up drinks.
RISK OF BURNS OR SCALDING
If cleaned when the nozzle is still hot, avoid
touching it with bare hands.
Use a cloth dipped in hot water and/or a neutral
cleanser.
8.5 CLEANING THE DROP
COLLECTING TRAY
GRID
Wash the grid clean with a brush and hot water
and soap.
EN
Fig. 30
CAUTION
Fig. 31
Fig. 32