Autosteam - Nuova Simonelli TALENTO Notice D'instructions

EN
TEA (Tea time):
Pressing this key from the cycle menu will
open the TEA cycle: press ENTER
the submenu; the
increase/reduce the time and therefore the volume
of the water.
Press ENTER to confirm settings.
MANUAL STEAM (Steam Time):
Pressing key from the cycle menu will open
the MANUAL STEAM cycle; press ENTER
to open the submenu; the
serve to increase/reduce the time of the steam.
Press ENTER to confirm settings.

AUTOSTEAM:

Pressing key from the cycle menu will open
the AUTOSTEAM cycle; press ENTER
open the submenu; the
to increase/reduce the temperature that the beverage
being heated needs to reach.
Press ENTER to confirm settings.
FINAL TEMP (final temperature)
Press the ENTER
The keys
increase/reduce the temperature required for the bev-
erage being heated.
Press ENTER
to confirm the setting.
AIR TEMP (air temperature)
Press the ENTER
The keys
increase/reduce the temperature at which the air com-
pressor switches off by a maximum of ±5°C.
Press ENTER to confirm the setting.
to open
keys serve to
keys
keys serve
key to open the submenu.
can then be used to
key to open the submenu.
can then be used to
DELAY (air delay):
It is possible to read the time at which the air com-
pressor switches on. After this time the compressor
pushes the air into the milk to create the foam.
Press the ENTER
Press RESET
4. SETTINGS
Pressing ENTER
sub menu and use the
the function to be programmed.
Press ENTER
4.1 COFFEE TEMP (Coffee boiler temperature)
It is possible to programme the temperature of the
water in the coffee boiler.
to
Pressing ENTER
sub menu; the
increase/reduce the temperature of the water in the
coffee boiler tank ( T permitted ± 3°C).
Press ENTER
4.2 STEAM TEMP (Steam boiler temperature)
It is possible to read the steam temperature in the
service boiler.
Pressing the ENTER
open the submenu.
Press the RESET
key to open the submenu.
to quit the setting function.
it is possible to enter the
keys to select
again to open the function.
is possible to enter the
keys are used to
to confirm settings.
key, it is possible to
key to exit the setting.
49