Filling The Coffee Container; Switching On; Switching Off - Nuova Simonelli TALENTO Notice D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The water hardness must be less then 4° - 6° fr
(french degree).
The chlorine content must not exceed 100mg per
litre (0.00000361lb/cu in).
Otherwise the conditions of guarantee of the
machine will expire.
The machine must be installed according
to the local standards in force with regard
to plumbing systems. For this reason, the
plumbing connections must be carried
out by a qualified technician.
4.2
FILLING THE COFFEE
CONTAINER
1
Remove the cap to access the granulated coffee
bean container.
Pour ONLY toasted coffee beans into the coffee
bean holder. any other kind of coffee, for example
ground coffee, will damage the coffee grinder.
Don't insert caramelized, sugar coated, or similarly
coated coffee beans, or instant coffee or other sug-
ary beverages because they will harm the appliance.
2
Don't fill to the brim but pour just enough toasted
coffee beans into the coffee bean holder to
ensure correct closure of the unit.
3
Close the cap.
40
WARNING
WARNING
Fig. 17
4.3

SWITCHING ON

NOTE: in case the following procedure shouldn't
take effect, see the chapter on "Problems
and Solutions".
After the preliminary operations:
Press the ON/OFF key
The machine will carry out a group positioning cycle;
this is the cycle for filling the boiler with water at the
end of which, if the machine is cold, there will be a
heating cycle and the display will read:
PLEASE WAIT
after the heating phase, the display will read:
SELECT PRODUCT
and the machine will be ready for use.
The heating stage takes approx, 5 minutes.
NOTE: The appliance is endowed with a security
system that will stop the machine after about
1.5 minutes of constant functioning of the
pump (to avoid pump overheating). In this
case, switch off the main switch of the
machine and then turn it on again.
The machine is now ready to be used.
WHEN INSTALLING FOR THE FIRST TIME OR
STARTING THE MACHINE AGAIN AFTER BOILER
TANK GROUP SERVICING, BEFORE SWITCHING
ON THE MACHINE AND STARTING THE HEATING
PROCESS, BE SURE TO FILL THE COFFEE
BOILER TANK, (PAGE 49 PARAGRAPH 8.3) UNTIL
THERE IS A REGULAR FLOW FROM THE WAND.
4.4

SWITCHING OFF

To switch off the machine, proceed as follows:
Press the ON/OFF key
EN
.
WARNING
.

Publicité

Table des Matières
loading

Table des Matières