Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Note: example representation
X) Seals (with O-ring) of the hydraulic connections
The feed-through in the insulation for the hydraulic and electrical connections are sealed off from
the environment by the special seals in the pump group insulation after professional installation.
Legend:
X.1
X.2
8.1
8.2
8.3
8.4
10
11
12
13
d, e, f, g
We reserve the right to change designs and technical specifications of our products.
Pipe feed-through halves for sealing
the union fittings
O-ring (55x3 mm) for fixing X.1
Rear section of the insulation
Rotatable insert for pump
Central insulating piece
Front section of the insulation (without
thermometer openings) and front panel
Sealing for 2x electr. cable feed-throughs
Double nipple 1" male thread with O-ring
(28x3 mm) x 1" male thread flat sealing
Seal 1 ½"
Transition piece 1" male thread (with SW36)
and UWM 1 ½" flat sealing
enclosed union fittings mounted,
for connections: see Chap. 2
13
Publicité
Table des Matières
