Siemens SINAMICS G130 Manuel page 950

<3>
[6722.6][6725.6]
<3> <3>
[6725.4][6730.5][6731.5][6732.4]
<3>
[6722.3][6725.4]
[6714.8]
[6310.8]
<3>
[6730.5][6731.5][6732.4]
[6060.7]
[6220.8][6320.8]
[6220.8][6320.8]
<1> Only for V/f control.
<2> Not for SERVO.
<3> Only for SINAMICS S120.
1 2
DO: SERVO, VECTOR
Internal control/status words - Status word, closed-loop control
Status word closed-loop control
Bit No. Meaning
0 1 = Initialization completed
<2>
1 1 = De-magnetization completed
2 1 = Pulses enabled <2>
3 1 = Soft starting available
<1> <2>
4 1 = Magnetization completed
5 Reserved
6 1 = Acceleration voltage active <1>
7 1 = Frequency, negative <2>
8 1 = Field weakening active
9 1 = Voltage limit active
<2>
10 1 = Slip limiting active <1> <2>
11 1 = Frequency limit active <2>
12 1 = Current limiting controller, voltage output active
13 1 = Current/torque limiting active
14 1 = Vdc_max controller active
15 1 = Vdc_min controller active
3 4
r0056.0
r0056.1
r0056.2
r0056.3
r0056.4
r0056.5
<2> r0056.6
r0056.7
r0056.8
r0056.9
r0056.10
r0056.11
r0056.12
<1> <2>
r0056.13
<1> <2>
r0056.14
r0056.15
5 6
fp_2526_54_eng.vsd
24.10.08 V04.03.01
p0115[1] (Motor Modules)
Refer to [1020.7]
ZSW closed-loop control
r0056
[2701.1][2707.1]
<3>
[8018.1]
[8012.5]
[6031.6][6710.2]
[6710.2]
7 8
Function diagram
- 2526 -
S120/S150/G130/G150