Error Codes; Warranty; Accessories; Materials In Contact With Medium - IKA LR 1000 basic Mode D'emploi

Error codes

The fault is shown by an error message in the display as following if the error occurs.
Proceed as follows in such cases:
• Switch off the device using the main switch
• Carry out corrective measures
• Restart the instrument
Error Description
code
Error 3 Internal temperature of device is too
(Er 3) high.
Error 4 Motor is blocked or overloaded.
(Er 4)
Error 10 Remote control is interrupted.
(Er 10)
Error 11 External temperature sensor plugged
(Er 11) during heating control.
Error 12 External temperature sensor unplugged
(Er 12) during heating control.
Error 14 Short circuit of external temperature
(Er 14) sensor or cable.
Error 17 The temperature of safety sensor is
(Er 17) higher than safety temperature setting.
Error 51 Mains voltage is too high.
(Er 51)
Error 52 Mains voltage is too low.
(Er 52)
Er 60  Power is interrupted when heating or
motor control is activated in Mode B
and C
 Only for LR 1000 basic!
If the actions described fails to resolve the fault or another error code is displayed then take one of the following steps:
• Contact the service department
• Send the instrument for repair, including a short description of the fault.
50
Effect Corrective action
Heating off - Switch off the instrument and allow it to cool
Motor off down.
Motor off - Switch off the instrument
- Decrease the load and restart again
Heating off - Change watchdog time
Motor off - Check relating connection
Heating off - Unplug the external temperature sensor.
Heating off - Plug in the external temperature sensor
Heating off - Check the external temperature sensor and cable
Heating off - Increase the safety temperature setting or allow
cooling down
Heating off - Switch off the device and check the mains
Motor off voltage.
Heating off - Switch off the device and check the mains
Motor off voltage.
– - Exit error state when any button is pressed.
In accordance with IKA warranty conditions, the warranty
period is 24 months. For claims under the warranty please
contact your local dealer. You may also send the machine
direct to our factory, enclosing the delivery invoice and giving
reasons for the claim. You will be liable for freight costs.

Accessories

T 25 digital Disperser
S 25 KV - 25 F Dispersing element
S 25 KV - 25 G Dispersing element
See more accessories on www.ika.com.

Materials in contact with medium

Reactor cover
Bottom
Reactor vessel
Anchor stirrer
Temperature sensor
Shaft seal
LR 1000.1
O-ring
LR 1000.3
O-ring
Scraper

Warranty

The warranty does not cover worn out parts, nor does it
apply to faults resulting from improper use, insufficient care
or maintenance not carried out in accordance with the in-
structions in this operating manual.
AISI 316 L / AISI 316 TI / PTFE / Borosilicate glass 3.3
AISI 316 L / AISI 316 TI
Borosilicate glass 3.3
AISI 316 L / AISI 316 TI
AISI 316 L / AISI 316 TI
PTFE
FKM
FFKM
PEEK
51