Ecolab My Control Manuel D'utilisation page 160

Software description
7.2.4.3.1 Pump
Fig. 51: Configuration -> Equipment -> Pump
Select the Pump
Selection of pump number
Direct dosing: in a tunnel compartment without rinsing.
Pump parameter:
n Pump calibration: amount in ml/min.
Dosing line: line number
n
n Flow meter calibration: number of pulses in (pulses/L).
Flow meter max time: Max time in (%).
n
n Flow switch delay: Accept time befor alarm in (s).
n Flowmeter enable: selection have to be done
n Flowmeter / Flowswitch activated: validation of the selection
n Low level alarm: activation low level on the selected pump
n Weight control dosage: dosing depending of the real or therotical weight
n Pump dose alone: pump running always alone on this dosing line
n Flush while dosing: dosing and rinsing in the same time
n Leakage alarm: dosing pulses detected when dosing equipment stopped.
Available Menue:
Back to Equipment:
Ä Chapter 7.2.4.3 'Equipment' on page 61.
see chapter
Back to Main Screen:
Ä Chapter 7.2 'System Start - Main Screen' on page 34.
see chapter
417101971 Rev. 2-02.2019 62