Ecolab My Control Manuel D'utilisation page 144

Software description
7.2.4.1 General
Fig. 32: Configuration -> General
Select all datas
Programmation standard:
n Reset alarm time: restart alarm after a time delay
n Stop Dubix time: impulse's time to stop Dubix WE
HELMS timeout: detection of no communication with Helms
n
n Intermediary rinse time: intermediate time if several products are dosing together
n Analog filter time: filter on analogic value
Selections possible:
n Alarm prog not finished disable: alarm deactivation for program not finish on the WE
n Flush ctrl enable: alarm authorization
Helms timeout enable: authorization alarm com (Helms)
n
n HELMS enable: activation report info to Helms
Reset button enable: authorizsation reset alarm with push button on cabinet
n
n Flush leak enable: authorization rinse leakage alarm.
n Separate air & stop alarm: using information about air pressure and emergency alarm
activated
n Choice on any push button to go in the request mode (Border in green means:
selected)
Available Menue:
Back to Configuration:
Ä Chapter 7.2.4 'Configuration level access' on page 45.
see chapter
Water Flowswitch allocation:
Ä Chapter 7.2.4.1.1 'Water flowswitch allocation' on page 47.
see chapter
Connexx:
see chapter Ä Chapter 7.2.4.1.2 'Connexx' on page 47.
Flush system:
Ä 7.2.4.1.3 'Flush system' on page 48.
see chapter
Language:
Ä Chapter 7.2.4.1.4 'Language selection' on page 48.
see chapter
Back to Main Screen:
Ä Chapter 7.2 'System Start - Main Screen' on page 34.
see chapter
417101971 Rev. 2-02.2019 46