Troubleshooting - Bosch HSLP451UC Manuel D'utilisation

en-us Troubleshooting
13 Troubleshooting

Troubleshooting

You can eliminate minor issues on your appliance your-
Troubleshooting
self. Please read the information on eliminating issues be-
fore contacting Customer Service. This may avoid unnec-
essary repair visits.
WARNING
Improper repairs are dangerous.
Only authorized service providers should repair the ap-
▶
pliance.
Issue
Oven is not heating
Baking results are not as expected The rack position in not ideal
Oven light is not working properly
Oven light does not turn off
Cannot remove lens cover on light There is soil build-up around the lens cover
Clock and timer are not working
properly
"E" and a number appears in dis-
play and control beeps
With a new oven there is a strong
odor when oven is turned on
Control does not react when a key
is touched
Warm air or steam escapes from
oven vent
Cooling fan runs even when the
oven is turned off
24
Cause and troubleshooting
There is no power supply to the appliance
Check circuit breaker or fuse box to your house.
1.
Make sure there is proper electrical power to the oven.
2.
There is no cooking temperature set
Set a heating mode temperature.
▶
Refer to the cooking charts for the recommended rack position. → Page 25
1.
Check "Getting the most out of your appliance" for tips and suggestions.
2.
→ Page 18
The oven light bulb is loose or burnt out
Replace or reinsert the light bulb.
▶
Tip: Touching the bulb with fingers may cause the bulb to burn out.
The oven door does not close properly
Check the oven door for obstructions.
1.
Check to see if the hinge is bent.
2.
The oven light is turned on
Press the oven light button to turn the oven light off.
▶
Wipe the lens cover area with a clean, dry towel, then try to remove the lens
▶
cover.
There is no power supply to the appliance
Check circuit breaker or fuse box to your house.
1.
Make sure there is proper electrical power to the oven.
2.
An electronics fault has occured
Press any button or turn any knob to stop the beeping.
1.
Reset the oven if necessary.
2.
Call an authorized service provider.
3.
This is normal with a new oven and will disappear after a few uses
Operate the self clean mode to burn-off the smell more quickly.
▶
The control is wet or soiled
Clean the control panel an wipe it dry.
▶
The touch keys are not pressed correctly
Press the center of the button.
1.
Use the flat part of your finger.
2.
It is normal to see or feel steam or warm air escaping from the oven vent
CAUTION
The oven vents are important for air circulation. Covering the oven vents will cause
the oven to overheat. Refer to the appliance overview for the location of the oven
vents. → Page 9
▶ Do not obstruct oven vents.
The cooling fan will continue to run, even after the oven has been turned off, until
the oven has cooled sufficiently
This is normal. There is no action required.
▶
If the power cord of this appliance becomes damaged, it
▶
must be replaced by the manufacturer, the manufac-
turer's Customer Service, or an authorized service
provider in order to prevent injury.
Only original spare parts may be used to repair the ap-
▶
pliance.
If the appliance has an issue, call Customer Service.
▶