Removing The Water Tank During Or After Operation; Preheating; Setting The Heating Mode And Temperature; Changing The Heating Mode - Bosch HSLP451UC Manuel D'utilisation

Fill the water tank to the "MAX" line with cold water. The
3.
tank holds 1.4 quarts (1.3 liters) of water.
Close tank lid until it snaps.
4.
Insert water tank completely so the tank handle is flush
5.
with the tank holder flange.
Ensure that the water tank rests level within the tank
6.
holder.
7.2 Removing the water tank during or after
operation
EMPTY THE WATER TANK AFTER EACH USE.
CAUTION
Exercise caution when opening the appliance. Standing to
the side, open the door slowly and only slightly to let hot
air and/or steam escape.
Keep your face clear of the opening and make sure
▶
there are no children or pets near the unit.
After the hot air and/or steam is released, proceed with
▶
your cooking.
Keep the appliance door shut unless necessary for
▶
cooking or cleaning purposes.
Do not leave the open appliance door unattended.
▶
Carefully open the appliance door.
1.
Keep the water tank level while slowly pulling it out of
2.
the appliance to ensure that no remaining water drips
down and out through the vent.
Pour out the water.
3.
Thoroughly dry the seal of the tank lid and the slot
4.
where the tank resides in the appliance.
Leave the water tank to dry with the lid open.
5.
Prolonged dampness could lead to a musty odor in the
water tank.
Close the lid and reinstall the empty water tank.
6.
7.3 Preheating
Depending on the heating mode, it is recommended to
place the food into the oven before or after preheating.
¡ For heating modes that use steam, place the food into
the oven cavity before preheating.
If you open the oven door during the preheat cycle the
steam will leave the oven cavity, lowering the tempera-
ture. The food will be undercooked.
¡ For heating modes Keep Warm, Slow Cook or Euro-
pean Conv place the food into the oven after preheat-
ing is complete.
7.4 Setting the heating mode and tempera-
ture
Requirement: For steam modes, place food into the oven
before starting the oven operation.
→ "Preheating", Page 15
From stand-by state, press the touch key for the desired
1.
heating mode.
Set a temperature within the allowed temperature range
2.
using the numeric keypad.
Press Enter.
3.
a The oven begins to preheat. The preheat bar on the dis-
play begins to fill up.
Note: You can also set a temperature first and then select
a heating mode.
7.5 Changing the heating mode
Press the new desired heating mode.
1.
a The current running heating mode is immediately ended
and the display enters editing mode.
If desired, enter a temperature with the numeric keypad.
2.
Basic Operation en-us
15