DT SWISS XR Serie Instructions D'utilisation Et Conditions De Garantie page 15

4.2.1 SINGLE SHOT
4.2.1.1 ADJUSTMENT OF THE REBOUND DAMPING
You can turn the red wheel on top of the right stanchion to adjust the rebound damping. Clockwise to get it slower, counter-
clockwise to get it faster.
4.2.1.2 LOCKOUT
The lockout closes the compression damping circuit. The fork cannot be compressed anymore. A pressure control valve, called
«Blow off», protects the system against damages caused by impacts on the fork while the lockout is activated. A whistling
sound can be heard when the blow off opens, this sound is normal and cannot be seen as a failure.
To activate the lockout turn the lever from position 1 to position 2
Pos 1
Pos 2
Single Shot
Lockout open
4.2.1.3 REMOTE LOCKOUT
MANIPULATION
To activate the remote lockout push the remote lever to position 2. To deactivate it pull it back to position 1.
ADJUSTMENT
• Deactivate the lockout function by pulling the remote lever to position 1. The cable of the remote lockout is loose.
• Screw the adjustment screw of the pipe until block
• Unscrew the adjustment screw step by step to adjust the tension of the cable
• Control the lockout function by pushing the remote lever from position 1 into position 2. The adjustment is correct once the
fork cannot be compressed anymore.
Pos 1
Pos 2
Single Shot
Lockout open
Single Shot
Lockout closed
Single Shot
Lockout closed
15