DT SWISS XR Serie Instructions D'utilisation Et Conditions De Garantie page 11

3.5 BRAKES
3.5.1 GENERAL INFORMATION
Maximum allowed disc brake diameters:
Model
DT Swiss XRC-Models
DT Swiss XRM-Models
DT Swiss XM-Models
DT Swiss EX-Models
INFORMATION
All DT Swiss forks, models 2009 onwards, are made for the post mount brake standard for a disc brake diameter of 160mm. For
disc brake diameters larger than 160mm, a special adapter from the brake manufacturer must be used
3.5.2 INSTALLATION OF THE BRAKE
CAUTION
Do not use screws that are too long for the mounting of the brake caliper. Screws that are too long may damage the post
mount socket. Make sure that the screw does not touch the end of the thread without clamping the brake caliper. The thread
depth of the screw in the fork should be between 8 and 10mm.
Tighten the bolts alternately with min 6Nm and max. 10Nm. The highest value required by the brake manufacturer should not
be exceeded.
When using disc brakes without Center Lock adapter or disc brakes with a spider arm construction, a collision test must be
made between the front wheel with mounted disc brake and the fork.
Do not affix the brake pipe to the crown. Scratch areas must be protected by a suitable sticker.
When using a DT Swiss fork the following installation of the brake pipe is recommended.
Max. diameter
185 mm
210 mm
11