Aim TTi TGR2050 Manuel D'instructions page 24

Status Commands
∗LRN?
LRN <character data>
EER?
QER?
∗CLS
∗ESE <nrf>
∗ESE?
∗ESR?
∗IST?
∗OPC
∗OPC?
∗PRE <nrf>
∗PRE?
∗SRE <nrf>
∗SRE?
SSR?
SSE <nrf>
SSE?
∗STB?
∗WAI
Returns the complete set up of the instrument as a hexadecimal character
data block approximately 108 bytes long. The syntax of the response is
LRN <data><rmt>.
To re–install the set–up return the block exactly as received, including the
LRN header at the beginning of the block, see below. The settings in the
instrument are not affected by execution of the ∗LRN? command.
Install data from a previous ∗LRN? command. Note that the LRN header is
provided by the ∗LRN? response block.
Query and clear Execution Error Register. The response format is
<nr1><rmt>.
Query and clear Query Error Register. The response format is <nr1><rmt>.
Clear Status. Clears the Standard Event Status Register, Query Error
Register and Execution Error Register. This indirectly clears the Status Byte
Register.
Set the Standard Event Status Enable Register to the value of <nrf>.
Returns the value in the Standard Event Status Enable Register in <nr1>
numeric format. The syntax of the response is <nr1><rmt>.
Returns the value in the Standard Event Status Register in <nr1> numeric
format. The register is then cleared. The syntax of the response is
<nr1><rmt>.
Returns ist local message as defined by IEEE Std. 488.2. The syntax of the
response is 0<rmt>, if the local message is false or 1<rmt>, if the local
message is true.
Sets the Operation Complete bit (bit 0) in the Standard Event Status Register.
This will happen immediately the command is executed because of the
sequential nature of all operations.
Query Operation Complete status. The syntax of the response is 1<rmt>.
The response will be available immediately the command is executed
because of the sequential nature of all operations.
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register in <nr1> numeric
format. The syntax of the response is <nr1><rmt>.
Set the Service Request Enable Register to <nrf>.
Returns the value of the Service Request Enable Register in <nr1> numeric
format. The syntax of the response is <nr1><rmt>.
Query and clear System Event Status Register. The response format is
<nr1><rmt>.
Set the System Event Status Enable Register to <nrf>.
Returns the value of the System Event Status Enable Register in <nr1>
numeric format. The syntax of the response is <nr1><rmt>.
Returns the value of the Status Byte Register in <nr1> numeric format. The
syntax of the response is <nr1><rmt>.
Wait for Operation Complete true. As all commands are completely executed
before the next is started this command takes no additional action.
23