Ryobi RBC26SBB Manuel D'utilisation page 70

EN
FR DE ES IT
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORISED SERVICE DEALER.
PROBLEM
Engine will not start.
Engine starts but will not accelerate.
Engine starts but will only run at
high speed at half choke.
Engine does not reach full speed
and emits excessive smoke.
Engine starts, runs, and accelerates
but will not idle.
Blade continues to rotate at idle
speed.
PT NL SV DA NO FI
English (Original Instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
1. Power switch is off.
2. No spark
3. No fuel.
4. Engine is flooded.
5. Starter rope now harder to pull
than when new.
6. Old fuel
Engine requires approximately
three minutes to warm up.
Carburetor requires adjustment.
Check lubricant fuel mixture.
Air filter is dirty.
Spark arrestor screen is dirty.
Idle speed screw on carburetor
requires adjustment.
Carburetor requires adjustment.
HU CS RU RO PL SL
SOLUTION
1.Make sure Switch is in the ON or "I" position.
2. The spark plug may be damaged, remove it
and check for dirt and cracks. Replace with a new
spark plug.
3.Push primer bulb until bulb is full of fuel. If
bulb does not fill, primary fuel delivery system is
blocked. Contact a servicing dealer. If primer bulb
fills, engine may be flooded, proceed to next item.
4. Remove spark plug, turn unit so spark plug
hole is aimed at the ground. Set start lever to "
" position and pull starter cord 10 to 15 times.
This will clear excess fuel from engine. Remove
any fuel which splashed on the product. Clean
and reinstall spark plug. Clean up any spilled fuel
and move at least 9m away before restarting. Pull
starter three times with start lever at "
does not start, set start lever to "
repeat normal starting procedure. If engine still
fails to start, repeat procedure with a new spark
plug.
5. Contact a servicing dealer.
6. Only use fresh fuel mixed with recommended oil.
Fuel over 30 days old may prevent the unit from
starting.
Allow engine to completely warm up. If engine
does not accelerate after three minutes, contact a
servicing dealer.
Contact a servicing dealer.
Use fresh fuel and the correct 2-stroke lubricant
mix.
Clean air filter. Refer to Cleaning the Air Filter
Screen earlier in this manual.
Contact a servicing dealer.
Contact a servicing dealer.
Contact a servicing dealer.
21
HR ET LT LV SK BG
". If engine
" position and