Cleaning And Maintenance - Bosch MaxoMixx MSM8 Serie Mode D'emploi

X Fig I
1. Place the prepared food in the blender
jug or other suitable receptacle or
process in the pan used for cooking.
2. Place the gear attachment on the whisk
and press until it clicks into position.
3. Place the whisk with the gear
attachment on the base unit and press
until it clicks into position.
4. Connect the mains plug.
5. Set the required speed with the speed
control (high speed recommended)
6. Take hold of the base unit and blender
jug and press the ON button Ã.
7. Process the food with the whisk.
8. Release the ON button after processing.
Wait until the drive comes to a standstill.
9. Disconnect the mains plug.
10. Hold down both release buttons
and remove the whisk with the gear
attachment from the base unit.
11. Remove the gear attachment from the
whisk.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 21

Cleaning and maintenance

The accessories used must be thoroughly
cleaned after each use.
W Risk of injury
Do not touch the blades of the universal
cutter of the ice crusher, cutting attachment
and dicer with bare hands. To clean, only
grasp by the plastic and use a brush.
Warning!
– Do not use cleaning agents containing
alcohol or spirits.
– Do not use sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Never immerse the following parts in
liquids or hold under running water and
do not clean in the dishwasher: gear
attachment, cover of the multifunction
accessory.
Cleaning and maintenance
Please note:
– Do not wedge plastic parts in the
dishwasher as they could become
deformed.
– When processing food such as red
cabbage or carrots, plastic parts may
become discoloured. This can be
removed with a few drops of cooking oil.
Fig. J gives an overview of how to clean
the individual parts.
Universal cutter / whisk
■ Only wipe the attachment of the
universal cutter and the gear attachment
of the whisk with a soft, damp cloth and
dry off.
■ Clean the other accessory parts with a
detergent solution and a soft cloth or
sponge or place them in the dishwasher.
Clean the blades with a brush.
Multifunction accessory
■ Wipe lid of the multi-function accessory
with a damp cloth only and dry.
■ The container, universal blade, carrier
disc and cutting attachments are
dishwasher-safe.
Carrier disc with disc inserts
■ Turn over the carrier disc to press out
the inserts (fig. E).
Disassembling dicer:
X Fig. H
1. Turn the dicer clockwise and remove
from the lid.
2. Undo catches and remove cutter disc.
3. Remove remnants from the cutting grid
using the cutting grid cleaner. Rotate
cleaner head to the corresponding
cutting grid size.
4. Take cutting grid out of the base holder.
■ Do not clean dicer parts in the
dishwasher, blades will become blunt.
Pre-rinse all dicer parts under running
water. Clean parts with a brush.
Subject to change.
en
21