Bosch MaxoMixx MSM8 Serie Mode D'emploi page 17

9. Rotate the lid in a clockwise direction
and remove.
10. Take out the blade/kneading hook.
11. Empty the container.
■ Clean all parts immediately after use.
X "Cleaning and maintenance" see
page 21
Sample recipes:
Bread dough
Basic recipe
– 250 g flour
– 140 ml water
– 7 g sugar
– 7 g margarine
– 0.5 g yeast
– 4 g salt
Tool: kneading hook
■ Add all ingredients except the water to
the container.
■ Mix ingredients on Turbo speed.
■ After a few seconds add the water
through the filling opening.
■ Process everything on Turbo speed.
Our recommendation: 11/2 minutes
switch-on time
Maximum switch-on time: 2 minutes
Maximum quantity: 1x basic recipe
Short pastry
Basic recipe
– 250 g flour
– 125 g margarine or butter
(room temperature)
– 125 g sugar
– 1 egg
– ½ packet baking powder
– 1 packet vanilla sugar
– 1 pinch salt
Tool: kneading hook
■ Add all ingredients to the container.
■ Mix ingredients on Turbo speed.
■ Chill the pastry dough.
Process further if required.
Maximum switch-on time: 2 minutes
Maximum quantity: 1x basic recipe
Multifunction accessory
Carrier disc with disc inserts
Slicing insert – coarse
for slicing cucumbers, carrots, potatoes,
etc.
Slicing insert – fine
for slicing cucumbers, carrots, beetroot,
courgette, etc.
Shredding insert – medium
for shredding apples, carrots, cheese, etc.
Grating insert – coarse
for grating potatoes for dumplings, potato
pancakes, fruit and vegetables for raw food
salads.
Caution!
The disc inserts must not be used for
cutting up very hard foods (Parmesan
cheese, chocolate).
The disc inserts are only suitable to a
limited extent for processing fibrous foods
(leek, celery and rhubarb).
W Risk of injury from sharp blade!
Exercise particular caution when handling
the inserts! Note the shape and position of
the insert when inserting into the carrier disc
(X Fig. D). Take hold of the carrier disc by
the designated recessed grips only. Do not
reach into the filling opening. Only use the
pusher when adding more ingredients.
X Fig. F
1. Fit the required insert into the carrier
disc.
2. Place the container on a stable, smooth
and clean work surface. Grasp the
carrier disc by the recessed grips and
insert.
3. Place the lid on the container (,) and
rotate anti-clockwise until it clicks into
position.
4. Place the base unit on the gear
attachment and press until it clicks into
position.
5. Insert the mains plug. Hold the base
unit. Press Turbo button Â. The
appliance remains switched on as long
as the button is pressed.
en
17