Bosch MaxoMixx MSM8 Serie Mode D'emploi page 16

en Multifunction accessory
■ Separate the egg yolks from the whites.
■ Beat the egg whites until stiff.
■ Beat the yolks and sugar, then add the
softened butter and the honey-apple
mixture.
■ Mix the flour, ground walnuts, cinnamon
and baking powder in a separate bowl.
Add to the moist ingredients and mix in.
Using a spatula carefully mix in the
beaten egg whites.
■ Line a rectangular loaf tin (dimensions
35 cm x 11 cm) with greaseproof paper
and pour in the prepared mixture.
■ Peel the apple and slice. Arrange the
slices on the cake.
■ Preheat the oven to 180 ºC and bake
the cake for 30 minutes.
Multifunction accessory
The multifunction accessory is intended for
the processing of foodstuff.
W Risk of injury from sharp blades/
rotating drive!
Never reach into the container while the
appliance is operating. Always use the
pusher to add ingredients. After switching
off, the drive continues running for a short
time. Change tools only when the drive
is at a standstill. When working with the
multifunction accessory, the base unit may
only be switched on when the lid has been
fitted and screwed on tight.
Warning!
Multifunction accessory must always be
completely assembled before use!
Caution!
Before cutting up meat, remove gristle,
bones and sinews.
The multifunction accessory is not suitable
for cutting up very hard food (coffee beans,
radishes, nutmeg) or frozen food (fruit, etc.).
Warning!
Always observe the maximum quantities
and processing times. X Table L
After each operation cycle allow
the appliance to cool down to room
temperature.
16
Universal blade/kneading hook
Universal blade
For cutting up meat, hard cheese, onions,
herbs, garlic, fruit, vegetables, nuts and
almonds.
Kneading hook
For kneading small amounts of dough.
W Risk of injury from sharp blade!
Do not touch the sharp edges of the
universal blade with bare hands. Take hold
of the universal blade by the plastic handle
only.
X Fig. C
1. Place the container on a stable, smooth
and clean work surface. Insert the
universal blade or kneading hook.
Important: The blade / kneading hook must
be positioned straight in the container.
2. Add food.
3. Place the lid on the container (,) and
rotate anti-clockwise until it clicks into
position. Insert the pusher in the feed
chute.
Note: If fitting the lid is a bit stiff, turn the
three-piece coupling on the underside of the
attachment slightly and try again.
4. Place the base unit on the gear
attachment and press until it clicks into
position.
5. Insert the mains plug. Hold the base
unit and multifunction accessory. Press
Turbo button Â. The appliance remains
switched on as long as the button is
pressed.
6. Process the food.
Add ingredients:
■ Release the button. Wait until the
appliance comes to a standstill.
■ Remove the pusher and add ingredients
through the filling opening.
■ Replace the pusher and continue
working.
7. Release the button after processing.
Wait until the drive comes to a standstill.
Disconnect the mains plug.
8. Hold down both release buttons and
remove the base unit.