Cleaning The Group Shower Screen, Shower Screen Containment Ring And Filter Holder - Astoria Core200 AEP Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 47
SAE version
• Press and hold the
group you would like to wash and immediately after-
wards, press and hold the
onds (the button should flash).
• To start the wash cycle, press the
and
buttons should flash) .
• Wait for the wash cycle to be performed (this takes rough-
ly 50 seconds).
• When the
button flashes to indicate that the wash
cycle has been completed, remove both the filter holder
and blind filter, then replace the coffee filter in the filter
holder.
• Reattach the filter holder to the dispensing group and
press the
button to start the rinse cycle.
• Wait whilst the automatic rinse cycle is being performed
(roughly 30 seconds); this is indicated by the
buttons flashing).
• All of the buttons will light up to indicate that the rinse
cycle has finished.
• Repeat the same operations for the other groups.
If there is a power failure during the wash or rinse
cycle, when the machine turns back on, the
button's LED will flash to indicate that the wash
cycle was interrupted.
The operation will need to be performed again to remove
any detergent remaining in the group.
User manual
button on the keypad of the
button for at least 5 sec-
button again (the
and
Cleaning the group shower screen,
7.5.4
shower screen containment ring
and filter holder
Daily:
Clean the dispensing group and filter holder shower screens
with the supplied brush on a daily basis.
Thoroughly clean the inside of the coupling ring and filter
holder, as well as the edge and the wings of the filter holder,
so as to eliminate any accumulated coffee residues.
0
1
2
Weekly:
Use the special toothbrush supplied (see the Spare
Parts Catalogue).
Clean the shower screen and shower screen containment
ring as follows:
• Loosen the screw using a screwdriver (1).
• Remove the shower screen (2) and the shower screen con-
tainment ring (3).
• Wash the two components with hot water.
• Reposition the shower screen and shower screen contain-
ment ring in their original position and lock everything in
place with the screw.
Core200
3
2
1
45
160
of

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Core200 sae

Table des Matières