Filter And Filter-Holder Cleaning - Astoria SABRINA Manuel D'utilisation Et D'entretien

8.5.2 Cappuccino-maker wash
Use special care in cleaning the cappuccino maker,
following the procedures indicated below:
do a first washing by immersing the suction tube in
water and run a delivery for a few seconds;
turn the rotating body (X) 90° to position B (closure
of milk outlet duct);
holding the milk suction tube in the air, dispense
steam (cappuccino maker dry run);
wait about 20 seconds to allow for internal cleaning
and sterilisation of the cappuccino maker;
close the steam and put the rotating body back in
position A;
if the air intake hole (Y) is blocked, clear it gently
with a pin.
Position A
X
Clean the cappuccino maker after each continuous use and at
least once a day.

8.5.3 Filter and filter-holder cleaning

Daily:
Soak the filter and filter-holder in hot water overnight
so that the fatty coffee deposits can dissolve;
rinse with lukewarm
water.
Weekly:
Use a screwdriver to de-
tach the filter from the
filter holder;
Soak the filter and filter
holder in warm water and cleaning agent for 10
minutes.
rinse with lukewarm water.
Caution: Only immerse the filter holder cup, avoid soaking the
handle in water.
The detergent must be diluted in cold water in the doses indicated
on the package (see manufacturer).
68 244
of
Y
Position B
8.5.4 Washing the group SAE version
To activate the washing cycle, perform the following
steps:
press and hold for 10 seconds the double espresso
button (2) on the control panel relative to the
grouphead to be cleaned, until the same button LED
begins flashing;
pour the detergent into the blind filter and attach the
portafilter to the grouphead;
press the double espresso button again (2)
while the machine performs the first washing cycle,
the leds of buttons
once the first cycle finishes and only the led of the
double espresso button
the portafilter from the grouphead;
press the double espresso button
proceed with rinsing;
while the machine is rinsing, the leds of buttons
(1) and (2) flash;
once the rinsing cycle is complete (approximately 30
seconds), the machine is ready for normal use.
1 2
The washing operations can be carried out simultaneously on
several groupheads. To exit the washing phase, the washing must
be completed on all the grouphead.
(1) and (2) flash;
(2) is flashing, remove
(2) again to
3 4 5
USER manual
;
6