Using The Machine - AL-KO BKS 2625 T Traduction Du Mode D'emploi D'origine

en
9. After the engine starts, press the speed regu-
lator briefly to release the starter so the en-
gine runs at idling speed.
CAUTION!
Avoid running the engine at high
speed when the chain brake is ap-
plied; this can cause the clutch to
overheat and become damaged.
10. Allow the engine to run for at least 1 minute
at idling speed before you start using the ma-
chine.
Warm start
For a warm start (immediately after the engine is
switched off), perform steps1 - 2 - 5 - 6 - 9 of the
procedure described above.
The notes in the "For your safety" section
must be followed closely.
Engine operation (Fig. 10)
Release the chain brake by pulling the
lever towards the operator before pres-
sing the throttle lever.
The chain speed is controlled using the speed re-
gulator (1) on the rear hand grip (2).
It is only possible to operate the speed regulator
if the interlock lever (3) is operated at the same
time.
The movement is transferred from the engine to
the chain via a centrifugal clutch which prevents
the chain from moving when the engine is idling.
CAUTION!
Do not use the machine if the chain turns
when the engine is idling; in this case,
you must contact the dealer for advice.
The correct working speed is achieved by moving
the speed regulator (1) up to the stop.
CAUTION!
Do not run the engine at maximum speed
during the first 6-8 hours of use.
Engine shutdown
To switch off the engine:
1. Release the control of the speed regulator (1)
and allow the engine to run at idling speed for
a few seconds.
2. Move the switch (4) to the "STOP" position.
46
Starting the engine, using the machine and switching it off
CAUTION!
When the speed regulator is moved to
idling speed, it can take a few seconds
before the chain comes to a complete
standstill.
If the machine does not switch off, ope-
rate the starter to cause the engine to
switch off by overrunning and immedia-
tely contact the dealer to establish the
cause of the problem and have the ne-
cessary repairs carried out.

USING THE MACHINE

Always consider that an incorrectly used
chain saw can disturb other people and
pollute the environment significantly.
For considerate use with regard to other people
and the environment:
Avoid using the machine in surroundings and
at times that can be disruptive.
Strictly observe the local regulations on the
disposal of cutting residues.
Strictly observe the local regulations on the
disposal of oil, damaged parts and all other
environmentally polluting substances.
During work, a certain amount of oil is re-
leased into the environment for the purpose
of chain lubrication; for this reason, only bio-
degradable oil specially intended for this pur-
pose is allowed to be used.
To reduce the risk of fire, do not put the
machine down amongst leaves or dry grass
when its engine is hot.
BKS 2625 T / BKS 2625 TSB