AL-KO BKS 2625 T Traduction Du Mode D'emploi D'origine page 38

en
As far as possible, avoid using the ma-
chine on wet or slippery ground, or in
any case on uneven or steeply sloping
ground if the user cannot achieve suffici-
ent stability during work;
Avoid steps and unstable platforms;
Do not work with the machine above
shoulder height;
Do not run, always proceed carefully and
watch out for unevenness in the ground
as well as the presence of potential obst-
acles.
Do not work alone or in remote places so
that you can quickly request first aid in
the event of an accident.
Press down on the machine firmly when star-
ting the engine:
Do not start the engine unless you are
at least 3 metres away from the place
where you filled the fuel;
Make sure that no one else is within
range of the machine;
Never point the silencer and conse-
quently also the exhaust gases towards
inflammable substances:
Pay attention to the possibility of material
being thrown out due to the chain move-
ment, above all if the chain encounters
obstacles or foreign bodies.
Do not alter the basic setting of the engine or
overrev it.
Do not expose the machine to excessive
forces, and do not use small machines for
heavy work. Using a suitable machine re-
duces the risks and improves the quality of
work.
Make sure that the chain does not move
when the engine is idling, and that after the
throttle lever is operated the engine quickly
returns to idling speed.
Make sure that the bar does not collide with
foreign bodies, and also pay attention to ma-
terial flying around due to the friction of the
chain.
The engine must be switched off:
If you leave the machine unattended.
Before refuelling.
Switch off the engine and remove the ignition
key.
38
Before you check the machine, clean it
or carry out work on it;
After encountering a foreign body. Check
if the machine has been damaged and
carry out the necessary repairs before
you use the machine again;
If the machine starts to vibrate abnor-
mally (immediately identify the causes of
the vibration and have the necessary in-
spections carried out at a specialist com-
pany).
If the machine is not used.
Avoid exposure to the dust and chips created
by the chain during cutting.
Maintenance and storage
Make sure that all nuts and screws are firmly
tightened so as to be certain that the machine
is always operating under good conditions.
Regular maintenance is essential for safety
and maintaining performance.
Never store the machine with fuel in the tank
inside a room in which petrol vapours could
come into contact with naked flames, a heat
source or sparks.
Allow the engine to cool down before you
place the machine in a room.
To reduce the risk of fire, always keep the en-
gine, the exhaust silencer and the fuel sto-
rage location free from saw chips, prunings,
leaves or surplus grease; never leave contai-
ners with cutting residues inside a room.
If you need to empty the tank, do this out-
doors with the engine cold.
Wear gloves whenever working on the cutting
device.
Always make sure that the chain is well shar-
pened. All work to be performed on the chain
requires technical skills and the use of spe-
cial tools.
For safety reasons, never use the machine
with worn or damaged parts. The damaged
parts must be renewed and are never allowed
to be repaired. Only use genuine spare parts.
Non-equivalent spare parts can damage the
machine and endanger the operator.
Before putting the machine away, make sure
that you have removed the spanners or tools
used for maintenance.
Store the machine out of reach of children!
BKS 2625 T / BKS 2625 TSB
Safety regulations