Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation page 8

charger. Charge battery initially at lowest charge rate, if
possible.
12. CHARGER LOCATION
a. Locate charger as far away from battery as dc cables
permit.
b. Never place charger directly above battery being
charged; gases from battery will corrode and damage
charger.
c. Never allow battery acid to drip on charger when reading
electrolyte specific gravity or filling battery.
d. Do not operate charger in a closed-in area or restrict
ventilation in any way.
e. Do not set a battery on top of charger.
13. DC CONNECTION PRECAUTIONS
a. Connect and disconnect dc output terminals only after
setting any charger switches/controls to ²off² position
and removing ac input connection.
DANGER—NEVER allow positive/negative connections
to touch each other.
b. Attach connections to battery and chassis as indicated in
15(e), 15(f), and 16(b) through 16(d) below.
14. FOLLOW THESE STEPS WHEN BATTERY IS INSTALLED IN
VEHICLE. A SPARK NEAR BATTERY MAY CAUSE BATTERY
EXPLOSION. TO REDUCE RISK OF A SPARK NEAR
BATTERY:
975-1023-01-01
a. Position ac and dc cords to reduce risk of damage by
hood, door, or moving engine part.
b. Stay clear of fan blades, belts, pulleys, and other parts
that can cause injury to persons.
c. Check polarity of battery posts. POSITIVE (POS, P, +)
battery post usually has larger diameter than NEGATIVE
(NEG, N,–) post.
CAUTION—The Negative (-) terminal of this battery
charger is grounded.
d. Determine which post of battery is grounded (connected)
to the chassis. If negative post is grounded to chassis (as
in most vehicles). This battery charger is not designed for
a battery positive referenced ground (chassis
connection) system, only use in a Negative grounded
vehicle system.
e. For negative-grounded vehicle, connect POSITIVE
(RED) connection from battery charger to POSITIVE
(POS, P, +) ungrounded post of battery. Connect
NEGATIVE (BLACK) clip to vehicle chassis or engine
block away from battery. Do not connect clip to
carburetor, fuel lines, or sheet-metal body parts. Connect
to a heavy gage metal part of the frame or engine block.
f. See operating instructions for length of charge
information.
g. When disconnecting charger, turn switches to off,
disconnect AC input power, remove connection from
vehicle chassis, and then remove connection from
battery positive terminal.
vii