Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation page 36

4. If using mounting bracket patterns A and D, fasten two
corrosion resistant, #10 round, pan head (or similar) screws
into the two pilot holes.
If using mounting bracket patterns B and C, fasten four
corrosion resistant, #10 round, pan head (or similar) screws
into the four pilot holes.
5. When using mounting bracket patterns A and D, align and
mount the Auto Charge using the internal bracket keyholes.
Slide the unit up or down to anchor it securely. Then fasten
the two remaining mounting screws through the two
external bracket keyholes.
6. When using mounting bracket patterns B and C, align and
mount the Auto Charge using the external bracket
keyholes. Slide the unit up or down to anchor it securely.
Then tighten the mounting screws in order to secure the
unit.
975-1023-01-01
Figure 7 Mounting Bracket Patterns
4.75"
121mm
A
B
12.5"
318mm
14.875"
378mm
NOTE:
For secure, permanent mounting, use all mounting holes in the
mounting brackets and fasten all the screws.
Pattern Dimensions
A Recommended mounting pattern used for other Kussmaul chargers.
4.75×12.5 inches (121×318mm)
B 4.75×14.875 inches (121×378mm)
C 10.4375×8.75 inches (265×222mm)
D 8.875×8.75 inches (225×222mm)
10.4375"
265mm
C
8.875"
225mm
D
8.75"
222mm
23