Interpreting Charger Information
The Auto Charge provides information about the status of the
charger and the batteries.
Reading Icons and Text
Figure 16 Charger and Battery Information
A B
3
G
BAT1 (LFP)
H
I
13.4 V
J
20.7 A
K
Bulk
975-1023-01-01
C
D E F
BAT2 (Flooded)
BAT3 (Flooded)
13.5 V
13.2 V
20.9 A
20.5 A
Float
Float
Item
A
Menu brings up a list of settings which allows the user to change
the configuration of the charger and the batteries.
B
Alert shows up when events are detected by the charger for
informational or diagnostic purposes.
C
Home takes you to the Home screen of the control interface.
D
USB appears when a USB drive is inserted in the USB port during
copying settings and updating firmware.
E
Fan icon appears and rotates when the unit fan is activated by the
Auto Charge.
F
Temperature shows a reading of the battery's temperature when
an optional Battery Temp Sensor (BTS) with 25-ft cable (PN: 091-
266-008-25) is also installed.
G
Battery Bank ID which corresponds to how the battery banks are
connected to the charger's three pairs of DC terminals.
(Indicates one of the six battery types – Flooded, AGM, GEL,
ODYssey, LFP (lithium-ion phosphate), and Custom.
H
Battery status graphic depicting four bars of remaining power.
Bars appear when a battery is physically connected and present at
the battery terminal. The bars also change colors from green to
yellow to red to indicate remaining power.
I
Displays the battery voltage reading.
J
Displays the charging current reading.
K
Indicates one of the four charging states of the battery (Bulk,
Absorption, Float, and Equalize) and one Standby state.
Interpreting Charger Information
Description
57