Kussmaul Electronics Kussmaul Chief Auto Charge Guide D'utilisation page 26

Figure 4 Configuration for Normal Loads
G L N
A
I
F
F
E
BAT2
E
BAT1
975-1023-01-01
J
C
B
D
F
E
H
BAT3
G
J
A AC source protected by correct size and
type of branch rated single-pole circuit
breaker
B DC positive (+) cable for BAT3 battery bank
(same cable type for BAT2 and BAT1)
C DC negative (-) cable
D DC negative bus
E BAT3 battery bank (also BAT2 and BAT1)
Preparing For Installation
F DC circuit breaker (80A DC Circuit Breaker
(PN: 090-0080-0)) near battery positive (+)
terminal (same for BAT1 and BAT2)
G Battery negative (-) cable (BAT3, BAT2, and
BAT1)
H BTS connected to lead-acid battery only.
c Do not connect to a lithium-ion phosphate
battery which has its own BMS that controls
temperature settings.
I DC auxiliary devices, such as a DC pump
J DC Aux positive (+) wires connect to the DC
device positive (+) terminals and DC GND
negative (–) wires connect to vehicle's
common Chassis earth bus.
13